Blue Springs, MO HVAC & Plumbing Services

Loose wire caused the control board not to come on. After fixing the issue, the furnace is up and heating. Thank you for choosing LBA services!

Dryer vent

Arrived to do a performance maintenance. Set up for combustion analysis, temperature split, static pressure test, and carbon monoxide tests. Verified operation of all mechanical and electronic components of the furnace. Checked blower for cleanliness and to see if there is any play in the bearings. Found the blower wheel is starting to get coated in dust debris. Checked systems heat exchanger to ensure proper venting of flue gas. Spoke with homeowner about the system. Furnace is operational at this time.

Completed furnace maintenance and inspection. I checked all components and amp draws. I tested airflow and temp splits. Furnace is running within manufacture specifications. I talked with customer about membership and what’s included with that. I attached the membership to the invoice so they can review the benefits. Furnace is running at departure.

N

N

N

N

Completed heat inspection for customer, all aspects of heating tested within, manufacturer specifications. Static pressures were elevated, adjusted blower speeds and static improved but still out of spec. Bacterial growth noted inside air handler, contacted field supervisor to advise customer on options to correct condition.

N

N

N

N

No answer from customer. Will continue to follow up.

L

L

L

L

Arrived to do a performance maintenance. Upon inspection of the system found that the vent has been leaking flue condensation into the furnace and utility closet. Set up for combustion analysis, temperature split, static pressure test, and carbon monoxide tests. Found that the system is operating with failing static pressure. Spoke with homeowner about the static pressure issue and how this can impact the furnace. Verified operation of all mechanical and electronic components of the furnace. Checked blower for cleanliness and to see if there is any play in the bearings. Found the blower wheel is heavily coated in dust debris. Checked systems heat exchanger to ensure proper venting of flue gas. Found large hot spots and excessive rust present. Heat exchanger is in “end of life” condition. Spoke with homeowner about the system. Furnace is operational at this time.

Met with customer regarding ducting needs to improve CFM. Following up with them tomorrow.

.

.

.

.

Completed furnace inspection for customer. All specs of system tested within manufacturer specifications. No recommendations at this time. Thanks you for letting us service your equipment today!