Overland Park, KS HVAC & Plumbing Services

Arrived to remedy an inoperable system. Upon inspection of the system found that the inside portion was moving air and sending signal to the outside unit. Went outside and inspected the outside unit. Found that the compressor is operational but the condenser fan is not doing anything at all. Performed diagnostic and found that the capacitor for the fan and compressor is fully failed. The only reason the compressor was operating was due to the compressor start kit installed on the system. Replaced the failed capacitor and tested the system further to ensure there are not any further issues with the system. Called homeowner and with their approval charged for the capacitor and buttoned up the equipment. Air conditioning system is functioning properly at this time.

Sold repair of about 1ft of inch and half pipe pvc to abs with hardcouplings only

Today I arrived and the thermostat for system #4 was on cooling and functioning properly again. The staff relayed to me that it had switched into heating again. Since this is a communicating thermostat and we have not been able to witness it switch into heat voluntarily I contacted the manufacturer’s tech support to confirm a diagnosis. While speaking with tech support they did recommend replacement of the thermostat and it’s control module as well as the room temp sensor to insure that there will not be further intermittent changeovers to heating mode. I sourced the parts and the t-stat as well as it’s control module are available locally however the room temp sensor for the adjacent classroom will need to be ordered in. It is possible to replace the t-stat and program the temp sensor out of the system until it arrives. I spoke with Morgan and she requested a written estimate so she can upline it for approval. Thank you, Jon

Duct cleaning

7-24-25 Work at 10216 w 87th PB&J world headquarters AC is not working east area Condener unit serial # 1914D15382 Found the condenser fan motor run capacitor was bad. This compressor does have a high temperature sensor in case it does overheat. Install new 10 MFD run capacitor for the condenser fan motor. Got the system running I did put my gauges on it just to make sure we’re doing all right. Good pressures. System is working at this time.

Went for water issue on system. Drain line was clogged hence for water to fill up. Did clear drain added bleach help clean line set. All electrical components are dry on system. System is up and running before leaving. Thank you for choosing LBA services-Johann

**((*****(****(*********** Please apply 1.5hrs labor. **(((((**(***(*(*********(* I spoke with David and he relayed to me that the upstairs heat-pump systems had water in the emergency drain pan. Both systems were checked. The east system was dry this morning and has been functioning all evening and night. The east system condensation pump and drain are functioning. The west system was not on when I arrived. I checked the condensation pump and it is functioning. The float safety in the drain pan did function. The drain line was checked for obstructions and it was clear. The system temps were in their proper range. The air filter was clogged and it was replaced with a client supplied filter. The evaporator coil was accessed and checked. The system was operated for 30mins and rechecked. The condensation drain is insulated however I did find water inside of the insulation. The drain line insulation was seamed and taped to prevent humid air from contacting it and dripping

*)*(*()**(**()*(*(*(*)&(&)&)&(&)&()&(&(&(&((&(& ERASE the paragraph below before invoicing please I cannot apply labor to this ticket. 3.5 hrs. Next step if it does it again would be to contact carrier tech support and go completely through the system. Of note all t-stats like this one in the building. Have em heat as a mode option. A factory reset or an “installers options” was not accessed nor could I locate an option for such. The manual was read and referenced. It was switched from programmable to non programmable to remove a variable. The unlock option was also not available. *)&(&)&&(&))&(&)&&(&)(&()&)*)*)*(&)&)&()&(&(&(&(&(&&*( The system was on heat when I arrived. I switched it over to cool and it functioned properly. The system was checked and there were no deficiencies discovered. I monitored the system and it performed properly. The room temp dropped from 85-77 in about 15mins. It reached the set point I set it at (71degf) and turned off. At this

Cleared drain and pop up assembly as well. Very good draining.

Clean whole house, cleaned coil and blower

Replaced eev thermistor

Went for a maintenance call today, tested for static pressure system is at the max rating. Checked evaporator coil and is clean with no restrictions. Temp split is passing for system. Refrigerant pressure are within range. All electrical components are passing for system. Did clean condenser unit for customer. System is up and running before leaving. Thank you for choosing LBA services-Johann

Reset toilet

7/22/25 - Completed a full cooling maintenance on all equipment. The filters were changed, the coils were cleaned, and proper operation was tested. Overall, all equipment was in good condition, it was all running well, and there were no issues found at this time.

When I arrived I went inside and located where the ceiling had dropped ceiling tiles. Got roof access and assess the system and found that the condensation line was completely clogged due to lack of maintenance on this unit. Filters are extremely dirty condenser coil’s are semi-dirty just needs upkeep on the system. At this time I cleared the clog and slowed the water from coming inside. Please allow some time for the duct work and insulation to dry.