Grandview, MO HVAC & Plumbing Services

Went for a maintenance call today for furnace. When going to furnace. Did static pressure test. Did have a high reading failing for system. Notified customer wants to leave as is at this time. Did CO testing, no carbon monoxide was detected at this time. Checked heat exchanger no wear and tear on heat exchanger. Did replace filter and cleaned out flame sensor. All electrical components pass for system. No further wear and tear. System is up and running before leaving. Thank you for choosing LBA services-Johann.

Na

Na

Na

Na

Re-ran flu pipe from 2 inch to 3 inch

Arrived to remedy an inoperable furnace. Upon inspection of the system found that it was displaying a fault code for combustion air. Performed diagnostic and found that the system is operating as it should but the vent piping is too long of a run to allow the furnace to operate. Coordinated with the office to arrange install to come out and upsize the combustion air ducting. Fixed the uv light, so that it only comes on when the systems fan is on. Tested static pressure and set the fan speed to the proper setting to bring the system within factory specifications. System is unable to heat until repairs are performed but will be able to cool and circulate the air.

Duct clean

Na

Na

Na

Na

Lowered static

Went for a maintenance call today. Upon arrival went to furnace. When testing for static pressure. Static is rated for .5 on system. System is operating at .6. Did replace filter for customer all vents are open. Blower speeds are set correctly. Had a field supervisor to retest. Supervisor will have solutions to fix static pressure. All electrical components are passing for manufacture specifications. Did notice one of the PVC was leaking. Did fix repair for customer. Cleaned out flame sensor. Did CO reading for furnace. No CO was detected. System is up and running before leaving. Thank you for choosing LBA services-Johann.

Sold 3 star

Full system

Came out here for a furnace tuneup upon arrival test static static pressure was failing who is straight into carbon monoxide test just to make sure that everything is functioning properly. I was getting a constant reading of ten to fifteen p.m. in the unit itself so I went ahead and check the heat exchanger, huge crack found in the heat exchanger unit had to be red tag and shut off.

Sa

Sa

Sa

Sa

Arrived to do a performance maintenance. Set up for combustion analysis and static pressure tests. Found system operating with failing static pressure. Reached out to a field supervisor to finish the diagnosis on the static pressure, and provide repair and replacement pricing. Verified operation of all mechanical and electronic components in the furnace. Cleaned the flame sensor and tested its performance. Checked blower for cleanliness and to see if there is any play in the bearings. Checked systems heat exchanger to ensure proper venting of flue gas. Performed an electronic gas leak search. Checked for carbon monoxide in the air stream. Spoke with homeowner about the system. With homeowners approval set up smart ac system and set up the app on their phone. Furnace is operational at this time.

Sold

Sold

Sold