Grandview, MO HVAC & Plumbing Services

-Installed new compression water stop shutoffs on hot & cold lines under bathroom sink -No cartridge for lavatory faucet so I installed a new same brand and style faucet -Removed broken shower arm out of wall and installed new shower head Thanks for choosing LBA Services! Your technician Jeremy

Na

Customer agreed to repairs of shower head and shower cartridge

B

Customer has water main leak in front yard, water main is 4’ft deep and need 45’ft replaced. Marked using white paint. Switching to supervisor tech to take over pictures posted to slack.

Completed full cooling maintenance. Changed all filters and cleaned coils. Mini splits I blew out with nitrogen. Tested all cooling functions and all are running as they should be at this time

Completed ac maintenance and inspection. I checked all components and amp draws. I tested airflow and temp splits. I cleaned up condenser coil. Airflow pressure is well over the max recommended airflow pressure. Compressor is starting up pulling 83 amps when the max rating is 70 amps. I noticed customer of current issues. Ac is running for now at departure.

Installed new water heater,

Completed furnace maintenance and inspection. I checked all amp draws and components. I tested airflow and temps splits. I cleaned up flame sensor. Customer notified me that the furnace was not efficient and was racking up his bill. I looked further into that and found that the blower speeds were set too low which was causing the furnace to have to run all the time to heat the home. I fixed blower speeds and adjusted gas pressures to have a 50 degree temp split I stead of being at the max temp split of 65. I notified customer of adjustments and the furnace was heating the home much better at departure. After fixing the furnace issues my only main concerns air the ac and water heater. The water heater is 26yrs old and not in good condition. It has signs of leaks and the flames have back drafted. The ac is 18 yrs old and uses R22 refrigerant. This refrigerant is no longer manufactured as of January of 2020. Any repairs that would include refrigerant on this unit could be very expensive.

Furnace checked out. Installing Water Heater 3/4

Out today to redo lavatory drain. Upon inspection determined that both labs were draining into same system, we will return tomorrow to perform work with proper scope. Thank you for choosing LBA Services!

Estimates

Inspected leaking pipe turned over to supervisor

Declined

Came out here for a furnace tuneup upon arrival test static static was feeling take a look at the rest of the unit cleaned out flame sensor, replace filter. I noticed that the heat exchanger had a lot of heat stress call supervisor to come out to take a second look at static pressure supervisor is out now thank you for choosing LBA

Main line sewer

C

1-30-25 Performed boiler tuneup on 1 boilers systems with 2-Burnham hot water boilers and air handler. Perform the following on both boilers. Blow out the burner ribbons Blow out the burner pilot assembly Tested the low water cut off safeties they’re working Check the circulating pump for any leaks or issues. pump is working properly. Both aqua stats are set at 150° and working properly Pressure was at 18 PSI The expansion tank in the ceiling. The side glass was completely full. This probably was causing the psi system pressure. I removed water from the tank. Got the system pressure to 12 psi, expansion tanks glass is currently at about 3/4 high. Air handler, I pulled the shroud from the blower assembly. Checked the bearings on the motor and the blower wheel bearings. grease both the motor and the blower wheel bearings. Look good properly alined, proper tension. Alan mentioned something about the air handler blower bearings were making some noise. However the noise was coming f

Bathroom

Nothing wrong with the systems. Just set wrong for temp on zoning system and was putting all heat in the wrong location. Spoke with will on what stats need to be set to what for proper function

X

Drain snake

Duct clean humidifier uv light

Replace the existing Carrier 125,000 btu unit heater serial 19R6289 for the Lab storage area. Price includes a Reznor 125,000 btu 83% efficient unit heater and room thermostat. Existing flue and utilities will be reused. New unit covered by a ten year heat exchanger, flve year parts and one year labor warranty. Includes removal and disposal of the existing equipment per EPA regulations. Existing smoke detectors will be reused if applicable. Non operational smoke detectors, fire panel interlock, energy management controls and energy management wiring will be the responsibility of the customer unless otherwise noted. Price does not include mechanical permits if required. Price does not include work outside of normal business hours, weekends or holidays. If there is anything required outside of what is indicated above, a price can be provided once the extent of the work is determined.

Quoted customer for new water cylinder on Humidifier. Looked at unit heater and found fan motor locked up. Called carrier and part is no lo ger available due to age. Will send quote for new system.