Blue Springs, MO HVAC & Plumbing Services

Spoke with customer

Spoke with customer

Spoke with customer

W

W

W

W

The broken furnace has a bad inducer motor and a cracked heat exchanger. One of the two other furnaces has a carbon monoxide leak. Thank you for choosing LBA services!

Went for a furnace inspection today. Did a static pressure test, it failed. Ducts are also very dirty. Filter got changed. Did a carbon monoxide and gas leak test, no leaks. Combustion analysis test passed. Inducer motor amperage passed. Gas pressure got adjusted to factory specifications and pressure switch passed. Temp split between the supply and return duct passed. Blower motor amperage passed and blower wheel is clean. Thank you for choosing LBA services!

L

L

L

L

Inspected heat exchanger. Tested for CO. No issues.

Customer. Called stating water pressure was too low, came out and adjusted to customers preference.

Arrived to perform previously diagnosed repairs. Before committing to the control board replacement, wanted to try one other possible cause of the system failure. Made sure the common wire on the thermostat was wired in. Made sure the common connection was strong to the furnace control board. Tested system operations. Furnace was still inoperable. Replaced furnace control board no found that each power lead for each electrical component of the furnace was placed on the wrong terminals. Made sure to trace out each wire to ensure that the proper part is connected to the proper terminal. Tested system operations. Furnace is functioning according to commands from the thermostat. Furnace is functioning properly at this time.

Dropped heaters

Installed new Full System

Checked in on furnace tune up. System is operating properly.

Came out here for a heating tuneup. Upon arrival tested static static was passing as well as CFM’s everything within the furnace was looking good. It was about eight months old filter was clean, clean flame sensor for the customer ensure that all operations within the heating cycle working perfectly fine. Did have to re-pierced the valve on the humidifier so it’ll work but humidifier working perfectly fine now customers happy with everything I explain to him. Thank you for choosing LBA services.- Ramon

Ordered parts confirmed warranty sold repair.

Arrived to remedy a fresh install that is not heating. Performed diagnostic and was unable to get the system to generate a fault code. Tested individual safety limits to ensure their operation. Verified airflow in the flue. After corresponding with an experienced field supervisor checked the wiring for the thermostat. Found that there was no c wire connected to the furnace control board. Made the necessary changes and tested system operations. Furnace is functioning properly at this time.

Arrived to remedy an inoperable furnace. Upon inspection of the system found the furnace sitting idle despite having a call for heat present at the furnace control board. Disconnected the thermostat and manually created a call for heat. After cycling power a couple times found that the system started up and ran. Tested system operations while it was running. Found the furnace operating as designed. Determined there is an intermittent communication error on the control board. Will confirm warranty and repair pricing on the morning once parts are located.

Inspection

Preformed plumbing inspection, presented findings to customer turned over to supervisor