Grain Valley, MO HVAC & Plumbing Services

Went for a maintenance call today. Tested for static pressure, system is passing when in cool. All electrical components are passing for manufacture specifications. Temp split is passing for system. Refrigerant levels is within range. Did clean condenser unit. As well replaced filter. System is up and running before leaving. Thank you for choosing LBA services- Johann

Coming back to finish work

Full system install

Called into office and canceled appointment

Went for an out on a system, did notice unit is not sized properly with an4 on coil and 3 ton condenser unit. Did check charge in system and is low on refrigerant. Temp split was off for system and didn’t meet specifications. Inspected evaporator coil and does have rust around it. Secondary heat exchanger and blower is dirty as well. System lacks of airflow going into the system. Hence for wear and tear on coil throughout the years. Did have a supervisor come out and will have solutions for customer with all options presented.

Blower duct cleaning

…

Arrived for ac check today. Started at furnace and checked static pressure, it’s running under the max rating. Blower wheel is clean. Motor amps are good. There is a 20 degree temp split. I replaced furnace filter. At the outdoor unit I rinsed coil clean. Pressures and charge look good. Compressor and fan amps are good. Capacitor tested in range. System is running upon departure. Thanks for choosing LBA.

Arrived to do a performance maintenance. Set system for cooling. Found that the furnace filter was impacted with debris. Replaced filter. Measured the systems static pressure and measured a temperature split between return and supply air. Checked interior of the furnace for cleanliness. Found that the blower wheel is collecting dust. Went outside and verified refrigerant levels. Verified operation of all electronic and mechanical components. Found that the capacitor for the condenser is failing on the compressor circuit. Replaced capacitor and cleaned up the electrical cabinet. Tightened all connections to and from the condenser control board so we can hopefully get more than a year out of the new capacitor. Rinsed coil free of debris. Spoke with homeowner about the system. Air conditioning system is operational at this time.

Went for a maintenance call today, tested for static pressure, system is passing when in cooling. All electrical components are passing for system. Refrigerant levels are passing as well for temp split. Did replace filter and cleaned condenser unit. System is up and running before leaving. Thank you for choosing LBA services-Johann

Arrived for ac check today. Started at furnace and checked static pressure, it’s passing. Blower wheel is clean. Indoor coil is clean. Motor amps are good. There is a 17 degree temp split. At the outdoor unit I cleaned the coil. Pressures and charge look good. Fan and compressor amps are good. System is running good. Thanks for choosing LBA.

Went for a service call today. Inside has good airflow and a clean filter. Outside system compressor wasn’t coming on and fan motor was weak. Checked the capacitor and it has failed. Replaced it and system it up and cooling. Thank you for choosing LBA services!

8-14-25 Walking in freezer, not working Griselda was not on site when I arrived. Check the walk-in freezer found I had no power to the evaporator or the time clock. Located at three pole breaker in the mechanical room where the water heater is the circuit breaker was in the position, not in the position. I turned the breaker on evaporate fans started up. Evaporator fans were running in low speed due to the thermostat was set at 40° when I lowered it down to 0° evaporator fans came out to high speed. I did test the defrost timer. The clock was off by about 12 hours set the proper time cycle. The unit by the defrost timer, defrost heaters are working. Let the unit run for about 15 minutes working at this time. My liquid line at the evaporator is warm to touch. I did not go up on the roof to check the condenser unit ,with the liquid line warm to the touch, if the condenser unit was not running. The liquid line will be either cold or be very hot. I spoke to Griselda via phone. I told h

Arrived to remedy a system that had completely shut down. Cycled power to the system and found that the system would start up and run as designed. Went outside and performed diagnostic on the system. Found that the compressor is drawing more amps than it’s rated for on startup. Determined that the system is in need of a compressor start kit. Spoke with homeowners about the system. With homeowners approval installed the compressor start kit. Tested system operations. Found that compressor start up amps went from 130 to 45, and running amps went from 10 to 8. Air conditioning system is functioning properly at this time.

Declined at this time on credit will try and come up with cash

Arrived to calibrate a fan to the system it’s being installed in. Turned system on and made adjustments to the fan speed. Turned system off and let it save the changes. Turned system back on and tested the systems performance. Kept making adjustments and cycling power to save changes calibrating the fans speed. Finally set the system for a 20 degree split between return and supply air. System is functioning properly at this time.

Installed blower motor, cleaned and re ran drain, cleaned up water out of secondary drain pan/coil pan, configured blower motor and still doesn’t work. I can force the blower to run through the app but the blower won’t run through the equipment as intended. Robby is working on the solution now. 8/6/25 11:45am

Arrived with Dre for ac out.

Failed blower motor. Replacing blower motor and cleaning blower wheel as well. Attic work , must be done early in the am

Dust clean and smart A/C system with blower motor

Duct cleaning quote. Thank you for choosing LBA services!

Arrived to do a dual system performance maintenance. Set each system for cooling. Measured each systems static pressure measured a temperature split between return and supply air. Found that the attic system is operating with failing static pressure. Checked interior of each system for cleanliness. Went outside and verified refrigerant levels. Verified operation of all electronic and mechanical components. Replaced a capacitor in the main system. Rinsed coils free of debris. Spoke with homeowner about the systems. Air conditioning systems are operational at this time.

Estimate

Completed ac tune up, fixed ac drain line, washed outside condenser

Sold water heater flush. WH pretty new but perfect time to stay on top of maintenance.