Overland Park, KS HVAC & Plumbing Services

B

Completed ac inspection all components tested to manufacture specifications. No recommendations at this time. Gave her some new filters while I was here

Customer wants to speak with a home warranty company before making any decisions on replacement

Went for a tune up today. Tested for static pressure, system is failing when in cool. Did check coil and has rust at bottom of coil. As well heated exchanger has rust spot and heat stress on it. Did check for refrigerant and is within range. Inducer motor is leaking. Capacitor is failing on condenser unit. Did show customer and is aware about concerns. Amperage is passing for fan and compressor. Did clean condenser unit. System is up and running before leaving. Thank you for choosing LBA services-Johann

Arrived for ac check today. Started at furnace and checked static pressure, it is running right at the max of .8. Blower wheel is collecting some dust. Motor amps are within specs. There is a 19-20 degree temp split. The duct work is dirty with dust and debris. At the condensing unit all pressures and charge look good. Compressor amps are good. Fan amps are running a little over the max. I rinsed coil clean. I also leveled the unit. System is running upon departure. Thanks for choosing LBA.

Completed ac inspection. All components tested to manufacture specifications. No recommendations at this time

.

Replaced check valves on sump pump

Sump pump is leaking

Arrive for ac check today. Started at furnace and checked static pressure, it is passing. Blower motor amps are good. Filter is clean. There is a 19 degree temp split. At the condensing unit all pressures and charge look good. All electrical components are running within manufacturing specs. Coil is rinsed clean. System is running and cooling properly. Thanks for choosing LBA.

This morning I checked in and was told that the newer York unit does not cool properly at times. I accessed the roof and checked the unit. There were no error codes present and the unit cycles with the thermostat. I checked the blower motor, compressor, outdoor fan, belt and checked temperatures. The temperatures are in the lower range of normal but still in a normal range. I accessed the ceiling and checked temps at the diffusers. The ceiling was accessed to ensure that the unit that has been condemned previously does not provide cooling to the classroom. I checked the charge check procedures for this unit and it is required to have 75degf to properly check the refrigerant charge. I relayed a reschedule to the dispatcher and this was discussed with the client. They will contact us if they feel that it is cooling adequately otherwise we will return and check the refrigerant charge when conditions allow. Thank you, Jon Tech notes: York rtu M/n ZQE06A2B1AA1A111A4, S/n N2H28

Will Have To Return

Customer called for no cool. Upon arrival system was running and outdoor unit was running. There was water on top of the furnace as well as on the floor. Pulled register from plenum and looked at coil it was not frozen but there was water sitting on top indicating it had froze. Customer stated they replaced air filter in the past week or two so I went to check pressures. Unit was very low on refrigerant, added 2lbs 9oz to bring system up to acceptable pressures and cool. Outdoor conditions were undesirable for adjusting charge as I stated to customer its close given the conditions. Customer had compressor replaced last year, they are going to check with contractor about warranty on that repair to see if it is covered. If not I assured them what was spent today would be applied towards any repairs needed from us if they so choose. Thank you!

Arrived for ac check today. Started at furnace and checked static pressure, it is failing. Motor amps are within specs. Blower wheel is dirty. Filter is dirty. There is a 22 degree temp split. At the condensing unit all pressures and charge look good. All electrical components are running within manufacturing specs. I rinsed coil clean. New filter and blower wheel cleaning were declined at this time. System is running upon departure. Thanks for choosing LBA.

Replace the Reznor 225,000 btu unit heater serial AML31H3N74568. Price includes a Reznor 200,000 btu 83% efficient unit heater. Existing room thermostat, flue penetration, mounting location and utilities will be reused.