Overland Park, KS HVAC & Plumbing Services

Went for an out for upstairs unit. Did check wiring and were in correct location. Voltage is correct for thermostat and furnace. System is cooling as well for main floor. With a passing temp split. Both system are running before leaving. Did sign up customer again which trip and diagnostic fee is waived off. Thank you for choosing LBA services-Johann

Arrived for ac check. Started at furnace and checked static pressure, it is running over the max. We’ve been out to discuss with you in the past, and you are aware. Blower amps are good. Blower wheel is clean. Three is a 21 degree temp split. I replaced furnace filter today. At the condensing unit all pressures and charge look good. All electrical components are running within manufacturing specs. I rinsed coil clean. Today you signed up for membership with smart AC and purchased a new Aprilaire 210 filter. System is running upon departure. Thanks for choosing LBA.

6-11-25 Performed AC tuneup on a champion high-efficiency split system. As part of the tuneup install, customer supplied high efficiency filter. shut down the humidifier, closing the bypass damper. James was getting some caution, warning and efficiency codes on his thermostat the past weeks. AC system was still working maintaining temperature in the house. I found there was a refrigerator leak on the liquid line outside by the condenser. I pulled back the refrigerant in the system back to the condenser. There was a small leak on the on the 3/8 copper line very small, but there was oil there also. I brazing at over the fitting, leak test the line set and the evaporator it held 400 pounds for a good 15 minutes while I did the AC tune up. Hose out thr condenser ,change of filters.r Evacuate line set and evaporator down to 500micron. Open the King valves system started and is running ran for about 15 minutes. I’m not getting any codes or any warnings. My sub cooling for the conditio

****((*((******((((((((*******(**(((*(*****((**((*****((*( Warranty call back for 1.5 hr (not our fault, your call to bill or not. Took a bit of time and climbing to map all t-stats 2hrs) The rest is billable at $139/hr No parts used **(*)*(******(*)*(*****(&(*(*(*(* Today the concern was that it was very cold in the front offices and showroom. In addition to this the other concern was that when the A/C was turned off at the will call desk it would still run. I spent a few hours turning off all thermostats in the front office then bringing them back online one by one. During this it was discovered that the thermostat in the will call office does not control the will call office. It does control the duct system directly next to it on the open floor plan. The thermostat that controls the climate in the will call office is located in the small divided off showroom adjacent to the will call office. The reason for the over cooling is due to a thermostat in the new supply office t

-Jack hammer floor near floor drain, at lowest point in basement. -Hand dig, approx 3 foot depth, approx 2.5 Foot circumference circle. -Remove all spoils from basement and dispose. -Install Sump Pump Pit Install Concrete around new sump pump pit -Install Zoeller M63 Sump Pump -Dig front yard, approx 40 feet length, to bury discharge line -Install discharge line, out front, and check operation. Thanks for choosing LBA Services! Your technician Jeremy Spencer

Went for an out for upstairs. Checked pressure and refrigerant for high side was extremely high. Did clean out unit and back to normal pressures. System is running before leaving. Thank you for choosing LBA services-Johann

Changed faceplate of thermostat. Dispatched for thermostat not working cooling. After a thorough inspection. It was discovered that the faceplate would not sit right on the backplate. This cause the system to not communicating. Replaced with a new faceplate and system is operating. Thank you for allowing us in your house to provide the perfect home service from your LBA Service tech Calvin. If I provided a positive or five star experience. I’d appreciate you sharing your thoughts in a review.

Arrived today to check out system that had low pressure lock out. I turned power to system off to reset system. Turned on and everything kicked back on. Capacitor is good. Running amps on fan and compressor are good. Both filters are clean. I hooked up gauges and it seems the charge is a little low. It’s probably just low enough that it was locking out for safety reasons. I added refrigerant to bring back to operating levels. System has been running for 1 hour and has not locked out. If there are any other issues, please call us back. System is running upon departure. Thanks for choosing LBA.

Estimate

Arrived for ac maintenance today. Started at furnace and checked static pressure, it is failing. The max rating is .5 and in ac it’s running at a .9, almost twice the max. Motor amps are running within specs. There is a 22 degree temp split. There is bacterial growth forming on the coil pan. At the condensing unit pressures and charge are ok. All electrical components are running within manufacturing specs. Coil is rinsed clean. System is running upon departure. Thanks for choosing LBA.

Found drain was back running and drain pan was full causing the air handler box to get water inside which led to a whole bunch of rust creating.

Drop replacement

Customer called for previously repaired system being out again. Found that wet switch in attic had tripped and was not allowing voltage to pass to condenser to engage. There was moisture in pan possible pan leak or potentially coil had froze and thawed activating switch. Told customer situation and we decided to leave for now and if it trips again we will investigate further.

B

Sewer smell