Overland Park, KS HVAC & Plumbing Services

6-26-25 Engineered air cold deck unit compressors #2 and #3 are tripping on high pressures safeties. There’s a pretty heavy buildup of cottonwood on the condenser coil. Also when I went to remove the side panels with the running, I couldn’t coils clogged up. I checked all six condenser fan motor make sure they’re running the proper direction and the proper they are. Spoke to Brian and Eric got up on the roof, Diego and I hosed out the condenser coil. Also use some condenser coil cleaner. Start the system back up currently all four compressors are running and you were running for a good 10 minutes with no issues. I did not check my actual head pressure however, when I went to remove the side panels on the condenser, they were a lot easier to remove.

Arrived for ac check on 2 systems. While checking the main floor system the refrigerant was almost empty. I found a leak in the evaporator coil. My field supervisor came out to discuss options. On the upstairs system all pressures and charge look good. All electrical components are running properly. The blower wheel is clean. There is an 18 degree temp split. This system is operating properly at departure. Thanks for choosing LBA.

Full system fix flu no humidifier new drop and furnace box and stat

-Installed a pop-up emitter for sump pump discharge line -Ran extension cord overhead in basement and plugged in sump pump

Customer wanted me to check all four roof tops for proper function. I checked each unit electrical components including amps on blower motor compressor and checked capacitors. All passed within range. Also check belts for wear or needing adjustment but all have pass inspection.All unit had a temperature split between 17 to 20. He is stating one unit is not working for the front of the restaurant but both in that area are working as it should be. Checked air flow from the registers and and have 54 degree out of the supply vent. At this time all units are running as they should be.

This quote is to install a new condenser fan motor in the existing condenser, including a new capacitor for both the condenser and the compressor Also replaced the two fuses that were blown. Note: this quote does not include today’s service call and troubleshooting. Installed a condenser fan motor, capacitor, and two 60amp fuses ran the system and got a 17 degree split at the furnace. At this time this unit is running as it should be

Furnace and a/c coil sold for Monday . 14 seer a/c coil 80k btu furnace

Full system replacement Monday. Thank you for choosing LBA services!

Arrived because system wasn’t keeping up. Looks like coil had froze, but it was thawed when I showed up. Water has leaked onto system. The outside coil was dirty, I rinsed it clean. I checked refrigerant it showed it was a little low. I added to make correct. Thermostat has already dropped 3 degrees. Running upon departure. Thanks for choosing LBA.

Called David this morning and left a message which he never got back to me. I just called him again and left another messsge. Might’ve ghosted us on this one

All right, so we have a couple issues going on one the condenser and the fan are amping a lot higher than they should. The system is having trouble running due to its age which is drying a lot of power and causing the capacitors to blow. Inside we have some pretty big cracks and separation on the heat exchanger where it meets the secondary heat exchanger. Best that moving forward is a complete system. That way we can get the new refrigerant and start fresh with a nice warranty.

Upon arrival I began by cleaning the outdoor unit of all cottonwood and debris. I then connected my refrigerant gauges to check the charge on the unit. The pressures were within specs as well as the subcool target was spot on at 10 degrees. I checked the running amps in the compressor and fan motor outside and both tested within specs. Also, I checked the dual run capacitor which is a size 40/5mfd and both sides were within specs. Next, I moved to the basement where the furnace was and checked the filter which was clean. I did recommend to the homeowners sister that the 3M brand of filters doesn’t allow very good airflow and that they can buy lower priced filters and change them out monthly. I tested the static pressure on the unit as well. The static max rating for this unit is .5 and it was testing at .46. The blower motor was running within manufacturer specifications and is still very clean. The ambient temp drop in the home was at 24 degrees which is within specs. System is runnin

Strawberry replaced the capacitor, but we have multiple issues with the system so I am changing the call

Includes a major reroute of sink and stand pipe-Includes raising Cleanout on 4 inch main line, adding a wye for new above ground sink/standpipe PVC to mainline.

Installed new a/c