Overland Park, KS HVAC & Plumbing Services

Arrived to do a performance maintenance. Set system for cooling. Measured the systems static pressure measured a temperature split between return and supply air. Found that the system is operating right at the systems maximum rated static pressure. Checked interior of the furnace for cleanliness. Found that the fan in the furnace that was recently cleaned is starting to collect dust again. Went outside and verified refrigerant levels. Verified operation of all electronic and mechanical components. Rinsed coil free of debris. Spoke with homeowner about the system. Air conditioning system is operational at this time.

Double return and moved water heater

Scheduled replacement hydrant

Completed an ac inspection, all components tested to manufacture specifications no recommendations at this time

Arrived for ac check today. Started at furnace and checked static pressure, it’s passing. Blower motor amps are good. Wheel is clean. There is a 20 degree temp split. Filter is clean. At the condensing unit all pressures and charge look good. All electrical components are running. I rinsed coil clean. System is running upon departure. Thanks for choosing LBA.

7-16-25 North center office area along the wall. AC is not working properly these way, bad damper, dry motor and pick one up and Northwest corner office the thermostat was wired backwards. I need to return on that one adjustment for the damper drive is the old style Temp master

7-15-25 Performed visual inspection of the 40 ton engineered air unit I did find number two compressor was shipped off on high head pressure. We can schedule a time to come back out and hose out the condenser circuit test all my condenser fan loaders they’re all running. It is 95° out right now so. Also, I have two areas better not cooling properly. Didn’t seem to be any airflow. I’m gonna come back tomorrow to check them

High static and possible oversized system. CX is comfortable for now and no other urgent issues are present. Posted notes in slack

For this job, I was performing routine maintenance on an air conditioner and furnace. upon checking the air conditioner, Everything seemed to be operating well within manufactured specifications. The furnace however, is showing very high static pressure. It is also pulling air from the basement, which is right next to the water heater. And there’s condensation issues as well, which is leaking water onto the heat exchanger and even into the furnace box, a supervisor has been called out to look at these advanced issues further.

All dampers are open and system is running. Thank you for choosing LBA services!

Arrived for ac check today. Started at furnace and checked static pressure, it is failing. Blower wheel is dirty. Evaporator coil has microbial growth on the pan. The inside of the coil is very dirty with hair and debris. The ducts are very dirty too. There is an 18 degree temp split. Blower motor amps are running high, close to max. I replaced filter. At the condensing unit all pressures and charge look good. All electrical components are running properly. I rinsed coil clean.

Completed an ac inspection. All components tested to manufacture specifications. No recommendations at this time

Sold relocation of water heater to make room for the second return drop and adding return grille on the side of stairs to basement plus duct cleaning. Also redoing the flue. $5075

Need to be done next Thursdays ,Friday, Wednesday

For this job I am performing routine maintenance on an AC and furnace. After checking the outdoor unit, it is showing some signs of wear and tear but pressures are good and all electrical components are operating fairly decent when I was checking the furnace. It is only five years old, but it’s starting to show signs of wear and tear on the heat exchanger. This is most likely due to the fact that we are missing air on the return side. Static pressure is above 1.0 and its maximum is 0.8. That and the fact that the ductwork has probably not been cleaned since construction are adding up to airflow issues that are not only costing energy and runtime cost to go up, but it is also harming the system.