Kansas City, KS HVAC & Plumbing Services

Upon arrival I began the furnace tune up. First, I ran a static pressure test. This unit has a max rating of .5 IWC for static pressure and your system is testing above the max allowed at .68. My Field Supervisor Jamie will discuss this with you further. Next, I checked the running amps on the inducer and blower motors and both tested within specs. The capacitor for the blower motor was a size 7.5mfd and is testing at 100%. The blower wheel itself has gotten very dirty and should be cleaned asap. I took a temperature split on the system which should be between 30 to 60 degrees and this unit has a temp split of only 31 degrees making the unit less efficient and takes longer to heat the home. I ran a combustion analysis on the exhaust gases and got readings that a unsafe to continue operating this system. I got 185ppm of Carbon Monoxide in the exhaust. Normal range is below 25ppm. I then checked the gas valve pressure to make sure that wasn’t causing the CO to be so high. The gas pressur

Duct butter and clean

Installed new Furnace FR801T0754A17UHSNA 2 year labor 10 year parts

80k btu furnace and whole home duct cleaning sold for tomorrow

Duct butter and duct clean and uv light

Furnace getting replaced. Thank you for choosing LBA services!

Went for a furnace inspection today. Did a static pressure test, it was high. CFM failed on supply and return. Combustion analysis test passed. There is no gas leaks. Inducer motor amperage passed, blower motor is over amping. Exhaust flu is in good condition. Temperature split between the supply and return duct passed. Thank you for choosing LBA services!

Customer needs complete duct rebuild and new system. Waiting on financing approval to green light project.

Arrived to assess repairs a system could need. Homeowner mentioned that another company came out and pressure tested the empty refrigerant system and found multiple leaks in the brazed connections. When checking these connections found oil, signaling what once was a leak. Checked over the rest of the system to ensure that once refrigerant repairs are performed the system will be able to operate properly. Found that the outside coil is heavily coated in debris and could use cleaning. Checked the inside portion of the air conditioning system. Found that the furnace had shut off due to the overheating safety. Tested the systems airflow and found that the system is struggling to move air. Without moving air properly the furnace will continue to overheat. Replaced the furnace filter. With the furnace over heating looked for any other things that would cause poor airflow and found that the blower wheel is heavily coated in dust debris. Found that the evaporator coil is impacted with debris,

Sold job

Sold job

W heater

Sold job

Sewer, PRV, shutoffs, halo

Preformed plumbing inspection, presented findings to customer, turned over to supervisor

Arrived to do a performance maintenance. Turned on the air conditioning system and started inspection inside. Measured the temperature split, static pressure, power consumption of the indoor fan. Went outside and measured the power consumption of the condenser fan and compressor. Verified refrigerant levels. Found that the signal wires for the condenser have been chewed on by the pups. Rinsed coil free of debris. Went back inside and checked over the system for cleanliness. Found bacterial growth on the evaporator coil and the indoor fan is starting to accumulate dust. Spoke with homeowner about the system. System is operational upon departure.

Installed new furnace and drop

Farhan brand new toilet wax ring complementary of previous job had done with LBA

Sold

Sold

Sold

Sold

Came out here for a furnace tuneup upon arrival tested static static was filling on the unit hooked up my combustion analyzer to read the readings within the flue pipe had extremely bad CO readings of 130 and climbing called supervisor to come out and take a look, we found out that the heat exchanger was under a lot of stress had a lot of cracks and a lot of rust which condemned unit to be faulty. Unit has been red tagged and field supervisor is talking with customer for further options

Walk through and picked up check

Replaced shut off for washing machine