Kansas City, KS HVAC & Plumbing Services

Filters dropped off for customer

No answer.

Went for an AC inspection today. Filter got changed. Static pressure test failed. Temperature split between the supply and return duct passed. Evaporation coil is clean and rust free. Outside system got washed. Refrigerant pressures passed. Compressor and fan motor amperage passed. Capacitor is weak. AC is up and running upon completion. Thank you for choosing LBA services!

Bad furnace search for finance options

5-21-25 Cancel this call everything‘s working

Gathered info for a replacement estimate for the outside condenser that has had both compressors fail. The electrical as well as the unit location and indoor AHU were also inspected for replacement. The gathered will be compiled and forwarded so we can provide a replacement estimate. Thank you, Jon Tech notes: Trane condenser, m/n TTA150B300FA, s/n 83032EHAD Serves foyer, kitchen and a few offices. 208/230 3ph, indoor air handler is in an attic equipment room. Will email info to Rick.

B

EST

Fan motor was replaced and AC was washed. AC is up and running after completion. Thank you for choosing LBA services!

Replacing Fan Motor

B

Sold job

Replace fan motor

5-19-25 Second floor, upper floor air handler, with the Trane condenser. VFD Just give me a fault code 16 over temperature motor. Spoke to the controller tech we made an adjustment to the amount of time before it does trip off give more time to cool itself down. This temperature is a calculation between frequency and amp draw. This is indication that the motor bearings are getting worn. There is no actual temperature sensor on the motor. This is all a calculation. I greased the blower motor bearing’s and also the blower wheel bearings. I’ll check the first floor bearings when I do the repair on the carrier condensing unit

High voltage issue with system. Thank you for choosing LBA services!

.

Install Customer supplied toilet

Went for a out, have a frozen coil that will need a day to thaw out will revisit to give full diagnostic on system.

*(*))*&))&(&)&)*((*)*)*(*)) notes indicate a T plus M billing however a planned maintenance billing item is on this invoice. ? 1) Labor + (2) filters + (1) 5uf cap OR? 1 invoice) Maint w/2 filters included 2nd invoice) 0.5 labor + 5uf cap Today a thorough cooling check and function test was performed on the two split-systems that cool the office. The filters were replaced and the outdoor units were washed. During this visit a capacitor that serves the outdoor fan motor in condenser #2 was replaced and checked after install. The systems are cooling properly with all tests in their proper range. A checkout sheet was completed and emailed to Eric. Thank you, Jon

Wanting to wait a week or so Togo with replacement, they are going on vacation at this time

*(*(*(*(*((**((*(*(**(**(*(*(****(** From shop (1) 16x25x1, service caps (2) TO BE CONTINUED *)*)*)*&&(&)&)&)&(***(*)*(*(*(***( Arrived and met with the office. There are two systems that are low. A leak search was performed on both evaporator coils and condensers today with no results. The breakroom A/C was filled with nitrogen to 200#s and no leak discovered. Removed hoses from lower shraders and discovered a small leak at the shrader core. Pulled a vacuum and charged the system. Tech notes: Tech room A/C temp split 11 (64-75), Ahu m/n AE48DX21G, s/n W2E2472801, Breakroom A/C Temp split 0 Filter packed (16x25x1)

Sold 15k btu mini-split $6800.

B

Install customer supplied fill valves

Na