Blue Springs, MO HVAC & Plumbing Services

Went for an out on system. Did find an error code of roll out switch. Did a hard rest for system cleared codes. Checked temp split on system is passing. Some wires were not secure did tightened. As well cleaned ground wire since having corrosion around. System is up and running again tested 4 times. Thank you for choosing LBA services-Johann

Arrived to do a performance maintenance. Set up for combustion analysis temperature split and static pressure tests. Found that the system is operating without failing static pressure. Verified operation of all mechanical and electronic components of the furnace. Found that the inducer bearings are making excessive noise. This is a sign of age and an impending failure. Checked blower for cleanliness and to see if there is any play in the bearings. Found that the blower wheel is heavily coated in dust debris. Checked systems heat exchanger to ensure proper venting of flue gas. Found that there is a crack beginning to form but has not reached the point of opening or being unsafe yet. Performed an electronic gas leak search. Spoke with homeowner about systems age and condition. With homeowners approval scheduled a blower cleaning for Tuesday morning. Furnace is operational at this time.

Completed furnace, maintenance and inspection. I cleaned flame sensor and wiped down the furnace. I checked all components and amp draws. I tested airflow and temp splits. I changed out air filter. Furnace is running within manufacture specifications. Furnace is operational at departure. Today I recommended surge protection for the whole home and/or the HVAC system. I explained where those get installed and how it protects the systems. I also informed customer that the manufacturer could avoid the warranty if the system gets shorted out by a power surge.

Went for an out today. Checked temp split for system and was failing. When checking charge is low on refrigerant. Will recommend to add refrigerant with uv dye and seal as well.

Arrived to do a performance maintenance. Set system for cooling. Measured the systems static pressure and measured a temperature split between return and supply air. Checked interior of the furnace for cleanliness. Found that the blower wheel is collecting dust. Went outside and verified refrigerant levels. Verified operation of all electronic and mechanical components. Rinsed coil free of debris. Spoke with homeowner about the system. Air conditioning system is operational at this time.

Arrived for ac not keeping up. System is not low on refrigerant and there were no leaks. I made a few adjustments to move more air through system. Temp splits are good. Refrigerant charge is good. If you feel there are still problems, please all us back. Thanks for choosing LBA.

Went for an out on system. Checked capacitor since compressor was off. Cap was failing, did replace capacitor. System is up and running now. Amperage for system is passing. No further wear and tear. Thank you for choosing LBA services-Johann

9-11-25 RTU #3 Install new inducer motor assembly. Tested for proper for proper amp draw and operation, working properly. Rated at 0.42 amps running at 0.17amp Tested system for proper combustion. O2 8.6%, CO 45, flue Temp349.6F RTU #4 Installed new ignition control module cycle system for proper operation working at this time. Installed spare belt on RTUs 3and 4 Also did some warranty work in the downstairs mechanical room thermostat wire was hanging down hitting the door and also the storage bins on the shelf. I secured the thermostat wire up into the overhead with wire ties. Original repair was done on May 7 2025 9-9-25 This quote is to make repairs to RTU #3 and #4 found during the heating check out today The labor on this quote is to do both repairs on the same day. RTU #3 Install new 2 speed inducer motor assembly. then test for proper operation and the heating system RTU #4 Install new ignition control module. Then complete the heating check out. During the tune

Went for a maintenance call today. Tested for static pressure, system is passing when in cool. All electrical components are passing for manufacture specifications. Temp split is passing for system. Refrigerant levels is within range. Did clean condenser unit. As well replaced filter. System is up and running before leaving. Thank you for choosing LBA services- Johann

Perform the fall heating service on four package units Number three and four have deficiencies that are listed on the sheets and we will give a quote for repairs

duct in dehumidifier

Arrived to remedy a mini split system that is leaking water all over the wall it’s mounted on. Inspected the power head and found that the fan for the unit was heavily coated in debris. Unit has been off for a while and the condensation pan was dry. Spoke with homeowner about repair solutions. With homeowners approval started a mini split cleaning. Diapsassembled the power head and removed the blower wheel. Cleaned the blower wheel outside. Used cleaning solution to clean the drain and the power head frame. Reassembled the power head and flushed out the condensation drain line. Tested system operations. System is functioning properly at this time.

Went for an AC inspection today. Filter is clean. Temperature split between the supply and return duct passed. Evaporator coil is very rusted. Outside system got washed. Refrigerant pressures met factory specifications. Compressor and fan motor amperage passed. Contactor has some burn marks. Filter dryer is starting to break down. AC is up and running upon completion. Thank you for choosing LBA services!

…

Full

Arrived to do a performance maintenance. Set system for cooling. Measured the systems static pressure and measured a temperature split between return and supply air. Found that the system is operating with failing static pressure. Checked interior of the furnace for cleanliness. Went outside and verified refrigerant levels. Verified operation of all electronic and mechanical components. Tightened all spade connections on the condenser control board. Rinsed coil free of debris. Spoke with homeowner about the system. Air conditioning system is operational at this time.

Full system replacement tomorrow. Thank you for choosing LBA services!

Full system.

Went for a maintenance call today. Tested for static pressure, system is passing when in cool. All electrical components are passing for system. Did replace capacitor since it was failing. Covered under parts and labor reason for replacement. Refrigerant levels are within range. Did replace filter and cleaned condenser unit. System is up and running before leaving. Thank you for choosing LBA services-Johann

Today (8/18/25) the blower motor for the furnace that serves the Brighton neighborhood was diagnosed as failed. In addition to this the blower wheel was also damaged. The voltage through the control board to the motor was confirmed. A new motor, blower wheel and a matching capacitor was sourced via Lennox and a repair estimate was created. The estimate was approved by Kim and Tyler. The parts were picked up at Lennox and brought on-site. The replacements were successful and the system returned to normal function after the repairs. The repairs are warrantied for one year from todays date including parts and labor. *This estimate includes both the diagnosis and the repairs listed on the estimate. Thank you, Jon Tech notes: Lennox m/n ML195UHO90XP60C-58//1716G28465 Diagnosed an electrically and mechanically failed motor. Blower wheel was damaged beyond use New blower motor, wheel and capacitor replaced Estimate written and emailed

Went for a maintenance call today. Static is passing for system when in cool. All electrical components are passing for system. Refrigerant levels are within range. Did clean condenser unit and replaced filter. System is up and running before leaving. Thank you for choosing LBA services-Johann

Arrived to do a performance maintenance. Set system for cooling. Measured the systems static pressure and measured a temperature split between return and supply air. Checked interior of the furnace for cleanliness. Found the blower wheel is starting to corrode and grow bacteria. Found that, on the side of the evaporator without the uv, there is bacterial growth forming. Went outside and verified refrigerant levels. Verified operation of all electronic and mechanical components. Rinsed coil free of debris. Spoke with homeowner about the system. Air conditioning system is operational at this time.

For this job, I was performing routine maintenance on a AC and condenser. Static pressure looked good filter was dirty but we swapped it out. Temperature difference was good with a split of 20° outdoor condensing unit looks good refrigerant levels and pressures are well within the green and I cleaned out the unit to ensure better efficiency. The only thing the system could really used to increase Efficiency is some insulation around the exposed ductwork on the supply side of the system in the basement and a surge protector. thank you for choosing LBA! - Walker

Arrived to do a performance maintenance. Set system for cooling. Measured the systems static pressure and measured a temperature split between return and supply air. Found that the system is operating with excessive static pressure. Checked interior of the furnace for cleanliness. Found large hot spots on the heat exchanger. This is caused by poor airflow due to the systems static pressure. Went outside and verified refrigerant levels. Verified operation of all electronic and mechanical components. Rinsed coil free of debris. Spoke with homeowner about the system. Air conditioning system is operational at this time.

Went for a maintenance call today. Tested for static pressure, system is failing when in cool. Did replace filter for customer. As well noticed blower wheel is collecting dust. Did inspect evaporator coil and is clean with no rust. Temp split passes for system. As well for refrigerant on condenser unit, did clean condenser. Tested for all electrical components are passing for manufacture specifications. Capacitor is running close to failing. But unit is still up and running. No further wear and tear in system. Thank you for choosing Lba services-Johann