Fairway, KS HVAC & Plumbing Services

11/11/25 - Completed a full heating maintenance on one furnace and two RTU’s. The filters were changed and proper operation was tested. The furnace and the RTU ending in 2560 were both running well, they were both in good condition, and they both had no issues at this time. Lastly, the RTU ending in 6372 is currently not heating at this time, the ignition board is burnt. It will need to be replaced, and it may also need to be diagnosed further to determine the cause of the burning or for any other issues, until then the unit will not be heating.

Called and left voicemail for customer regarding his email question.

Referred by HVAC Tech. Water line has electricity. Upon arrival found water treatment system to be faulty and causing a ground wire issue. After speaking to customer, customer would like to remove water treatment system. Also expansion tank installed on hot side and causing tension on water lines. Expansion tank is bursted. Informed customer of findings . Customer also wants us to check shower valve upstairs. Shower valve cartridge needs replaced. This type of shower valve is custom and would need to special order parts for it. Gave several estimates to customer and customer chose to get treatment system removed along with relocating expansion tank for both water heaters. Went ahead and removed treatment system and performed water line repairs. Installed new expansion tank along proper support and installed it on the cold side. Checked for leaks and no leaks detected.

Arrived to do a multi system performance maintenance. Set up for combustion analysis temperature split and static pressure tests. For each furnace. Found that the fan speeds were wrong on the new furnaces. Made the necessary changes and retested. Found that the attic system is operating with excessive static pressure. Verified operation of all mechanical and electronic components of each furnace. Checked blowers for cleanliness and to see if there is any play in the bearings. Checked each systems heat exchanger to ensure proper venting of flue gas. Performed an electronic gas leak search. Verified operation of each humidifier. Found that all panels are coated in calcium buildup, and the shutoff valve for the “kitchen” system is leaking and has been shut off. Spoke with homeowner about the each systems needs. With homeowners approval replaced the furnace filter in each system(rated for up to a year). Replaced humidifier panels in each humidifier. Replaced the leaking saddle valve with a

Went for a maintenance call today for heat. Tested for static pressure system is passing when in heat for all 3 systems.All electrical components are passing for manufacture specifications. Did a combustion test is within range. Inspected heat exchanger no cracks/leaks were detected in all 3 systems.Checked temp split and is passing. Did replace filter for customer for all. 3 systems. Cleaned flame sensor and pressure switch hose. Did fix wiring for system 1. As well replaced water panel for system 2. All systems are up and running before departure. Thank you for choosing LBA services-Johann

10-24-25 Install new pressure regulator and two sets of contacts need to return to complete the contactors in Michelle‘s office Reheat box #1-replace the two burnt and pitted contactors--$485.74 Reheat box #3-replace the two burnt and pitted contactors--$485.74 Reheat box #11-replace the pneumatic relay that is broken and leaking air above the grid--$930.31 Reheat box #15-replace the two burnt and pitted --$485.74 Prices include parts, labor and shipping of the special order pneumatic relay. Repairs covered by a one year parts and labor warranty.

10-7-25 Start the fall heating system check out Engineered air unit replace filter filters grease the blower motor and blower wheel pillow bearings checked operation of the blower system only. Check the electrical components Did a visual inspection of the RTU compressor area and electrical components. System air compressor. Checked pressures and operation Checked electrical components Check the oil level Check the compressor motor amperage matches the rating on the compressor itself

B

Went for a tune up today, did a co test did get a high reading. Heat exchanger had slot of heat stress in all chambers. Rust on eye lids and rust spots in chambers as well. Did have a supervisor come out to evaluate and rechecked reading, were the same. Also found under motor leaking. When checking ac did find capacitor is failing. Will send estimates to customer. Thank you for choosing LBA services-Johann

….

Pull and reset toilet estimate provided and sold.

Pulled and reset toilet

Dispatch for AC not cooling. At arrival the system was not operating after a thorough diagnosis. It was found to have a faulty capacitor. Replace capacitor, rinsed coil and checked refrigerant pressures system is operating and cooling at this time. Thank you for allowing us in your house to provide the perfect home service and for being a member of the perfect family service club from your LBA Service tech Calvin. If I provided a positive or five star experience. I’d appreciate you sharing your thoughts in a review.

-Includes removal of concrete, digging down to removal all soil, install pea gravel and sump pump pit, concrete new pit In place, Install Sump Pump, and ran discharge line out of house and into gutter system -Capped off 1/2” copper line with 1/2” pro press cap Thanks for choosing LBA Services! Jeremy Spencer

Arrived to remedy a mini split head making a ticking noise. Upon arrival found the mini split head stripped down and operating. Homeowner mentioned how the mini split head is leaning off the wall a bit and that it was making a ticking noise while operating. Set the fan to run at all different speeds and ran it in dehumidification and cooling modes and was unable to recreate the noise. Climbed up to the unit and saw that one of the Sheetrock anchors had pulled through the wall. Disassembled the head and made sure the fan was installed properly. Ran the system in the different fan speeds and modes. Did not hear any ticking noises. Prepared an estimate to dismount the head and re-secure the mounting bracket and re-mount the head. Spoke with homeowner about repair solutions.

Arrived back to check out system. Refrigerant was low and capacitor was bad. With approval I replaced capacitor and added refrigerant to make correct. It did take almost 3 lbs to fill, there could be a leak. If you have any concerns, call us up. There is now an 18-19 degree temperature split, which is good. System is running upon departure. Thanks for choosing LBA. Don’t forget to call in and set up membership!

Arrived for ac out. Upon arrival I found the wet switch was tripped. The pan was dry though, so could have been a bad switch. I replaced the switch. System started up. The filter was very dirty and I changed it. There was only a 14 degree temp split and it needs to be at 20. I went outside and check charge and it was reading low on refrigerant. The capacitor has also failed. It will need to be replaced. System is running for the night, we will be back in the morning to diagnose further.

B

Sold sump pump pit

-Hose bibs were isolated by ball valve near main shutoff -Ball valve turned on and hose bibs are working properly

Install Novo Whole Home Water Softener THE SYSTEM: Whole House Water Softening System (1.5 cu.ft) Prevents wear on your Plumbing System Downflow Regeneration Automatic Regenerating, Metered for Efficiency External Bypass for easy isolation Sodium or Potassium capable Professional Installation by Company Employee Installation with industry approved materials Connect to Approved Drain Discharge Connect to Approved Electric Outlet Program system for optimum efficiency

Presented options - customer selected Novo, for Tuesday install.

Rescope with Camron

Done system leveled

Evaluation completed